I posted it on the Facebook support group first for feedback. There have been some people asking questions about it here, so I thought this may help someone searching for more info. I have better results with lower flow rates (dia 0.4 or 1900%), but more testing needs to be done. I finally finished up my review on the Cetus3D Printer yesterday. Filament diameters of around 0.38 translate to the 2200% cmeyer posted (flow rate factors in quadratic, so use fine steps when adjusting it). Flow rate percentage adjustments mess up the ‘layer view’ in Cura (from years of experience with an Ultimaker 2, I find this one of the most helpful features in Cura). Keep in mind that you may have to find a physical solution for levelling the build bed when using Cura.ĭ) With the current version of Cura (v3.3.1) it is better to adjust the flow rate of molten filament via the filament diameter, than the flow rate percentage. The nozzle is too far away from the bed, if the individual lines can be easily separated and do not stick together.)Ĭ) Up Studio allows for an 9-point calibration routine for the z-axis. The nozzle is too close to the bed, if the brim thickness (z-direction) gets to thin and translucent. ![]() If you use a brim around a test-model in Cura, the correct height is achieved, if the individual lines that make up the brim squash together nicely. (I think a painfully precise calibration is overkill. Need Help Email: Phone: 86-10-64338663 (Monday to Friday 9am 6pm GMT+8:00) Cart 0. I did compile my ‘own version’ from the start code by chrisevich. Perhaps the info below will help someone in the future:Ī) I used the start and end code from chrisevich ( #11) which worked nicely for me.ī) the z-axis calibration code posted by cmeyer never worked for me. I just wanted to thank everyone who contributed to this thread - it helped me tremendously when setting up my Cetus3D MkII with Cura. Basic versions do not include heated bed or auto-leveling probe, while Deluxe version have them all provided. 4 Versions (two basic versions and two deluxe versions) are provided for your choice. Inherited classic features from Cetus MK1 & MK2, we make it an upgradable 3D Printer. ![]() G1 X50 E360 F300 extrude a 5cm purge line Cetus 3D Printer MK3 is the latest version of Cetus3D Printers. G1 X2 Y178 F5000 move to back right corner Buy Cetus2 here and ship from USA warehouse. ![]() M206 X-180 offset X axis so the coordinates are 0.180, normally they are -180.0 This is the Cetus3D online store for United States customers. Do the paper test and use a gcode file something like this:p.p1 the nozzle offset may be different than in Cetus Studio. make sure your nozzle offset is correct in the starting g-code
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |